Advertisement
17. Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is in the "3 o'clock"
position
and
that the Cable is routed around the Pulley
as shown,
Tighten the 3/8" Nylon Locknut
(21) and 3/8" x 3 1/2" Bolt (not shown).
Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Front Upright (42). Be sure that the Cable
Trap (not shown)
is turned to hold the
Cable in place and that the Cable is routed
around
the Pulley as shown, Tighten the
3/8" Nylon Locknut (21) and 3/8" x 3 3/4" Bolt
(not shown).
18. Attach the end of the Short Cable (58) to the
Long "U"-Bracket (57) with a 1/4" Nylon Lock-
nut (2) and a 1/4" Flat Washer (10). Do not
completely
tighten
the Nut. It should
be
threaded
onto the end of the Cable only a
couple
of turns.
19. Attach the Backrest (41) to the Front Upright
(42) with two 1/4" x 2 1/2" Screws (43) and
two 1/4" Flat Washers (10).
20. Press a 1 1/2" Square Inner Cap (32) into the
Seat Frame (36).
Insert the 1/4" x 2" Carriage Bolt (38) through
the center hole in the Seat Plate (37). Attach
the Seat Plate to the Seat (13) with two 1/4" x
1/2" Screws (18).
Insert the 1/4" x 2" Carriage Bolt(38) through
the indicated hole in the Seat Frame (36).
Tighten a 1/4" Nylon Locknut (2) with a 1/4"
Flat Washer (10) onto the Carriage Bolt.
Attach the other end of the Seat (13) to the
Seat Frame (36) with a 1/4" Flat Washer (10)
and the 1/4" x 2" Screw (24).
17-b
18
19
2O
43
13
;
37
32
11
Hide quick links:
Advertisement
