Care And Cleaning; Inside; Outside; Replacing The Light Bulb - Electrolux MRT18CSHD1 Owner's Manual

Table of Contents

Advertisement

Fresh Food Storage
(continued)
Adjustable
Air Flow Control
(some models)
Care and Cleaning
Damp objects stick to cold
metal surfaces. Do not touch refriger-
ated surfaces with wet or damp hands.
Deli Drawer
(some models)
Some models are equipped with a dell drawer Forstorage of luncheon meats, spreads,
cheeses, and other dell items.
Meat
Keeper
(some models)
The temperature
in the Meat Keeper can be made colder than the rest of the
refrigerator compartment by using the adjustable air Flow control. Foods can be
partially Frozen and kept Fresh longer than if stored on a refrigerator shelf. Before
placing Food in the Meat Keeper, Follow these steps:
1. Carefully handle Food items with clean hands and always keep drawer clean.
2. Store meat or Fish in the original wrapper. If necessary, overwrap in plastic wrap
or Foilto prevent drying.
3. If Food spoilage occurs, disinfect the drawer with liquid chlorine bleach Following
label directions. Wash with a solution of baking soda and water. Rinsewith water
and dry.
Keep your refrigerator and Freezerclean to prevent odor build-up. Wipe up any spills
immediately and clean both sections at least twice ayear. Never use metallic scouring
pads, brushes, abrasive cleaners or strong alkaline solutions on any surface. Do not
wash any removable parts in a dishwasher.
Always unplug the power cord from the wall outlet before cleaning. Turning
the control to OFF does not disconnect power to the controls, light bulb, or other
electrical components.
Inside
Wash inside surfaces of the refrigerator and Freezerwith a solution of 2 tablespoons
baking soda in 1 quart warm water. Rinse and dry thoroughly. Be sure to wring
excess water out of sponge or cloth when cleaning around the controls, light
bulb, or any electrical parts.
Wash removable parts such asshelves and drawers with baking soda solution or mild
detergent and warm water. Do not use harsh cleaners on these surfaces. Rinse
and drythoroughly. Clean the door gaskets with mild suds, rinse with clearwater and
wipe dry. Do not use razor blades or other sharp instruments which can scratch the
appliance surface when removing adhesive labels. Any glue left From the tape or
energy label can be removed with a mixture of warm water and mild detergent, or,
touch the residue with the sticky side of tape already removed. Do not remove the
serial plate.
To avoid damage and help
the refrigerator
run as efficiently
as
possible,
clean
the
condenser
periodically.
DEFROST
WATER
PAN
Outside
Wash the cabinet and handles with warm water and mild liquid detergent. Rinse well
and wipe dry with a clean soft cloth.
When moving the refrigerator, pull straight out. Do not shiR the refrigerator from side
to side asthis may tear or gouge the floor covering. If the refrigerator has an automatic
ice maker, be careful not to move the refrigerator beyond plumbing connections.
Periodically clean the condenser (black tubes and wires on the back of the
refrigerator). Using a vacuum with its dusting tool attachment, vacuum the coils to
remove dust build-up. Do not allow lint or dust to accumulate on the coils.
The defrost water pan is located at the bottom rear of the refrigerator on top of the
compressor (shown leR). The pan should be cleaned periodically. Wipe clean with a
damp cloth.
Replacing the Light Bulb
To replace the light bulb:
1. Ldnplugthe refrigerator.
2. Wear gloves as protection against possible broken glass.
3. Replace old bulb with an appliance bulb of the same wattage.
4. Remember to plug the refrigerator back in.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mrt18cshw0Mrt18cshw1Mrt18cshd0

Table of Contents