Assembly (continued)
Fig. 3-4
Fig. 3-6
Cutting
Attachment
(3) Screws
Shield
\
Gear Housing
Shield Mount ___,..I
Fig. 3-7
INSTALLING
THE HARNESS
Always use the shoulder harness when using the
cutting blade to avoid serious personal
injury.
1.
Push the strap through the center of the buckle.
2.
Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 3-4).
3.
Put the harness on over head and onto shoulder.
Snap it on to the support fitting (Fig. 3-5).
4. Adjust length to fit the operator's size. Pull tab to
lengthen, pull strap to shorten (Fig 3-6).
REMOVING
AND INSTALLING
CUTTING
ATTACHMENT
SHIELD
Remove the cutting attachment shield when using
the unit as a brush cutter.
The cutting attachment
shield should NOT be
installed when operating
the unit with a blade.
Remove the cutting attachment
shield before
removing
or installing the blade.
Remove the cutting attachment
shield from the shield
mount by removing the three (3) screws with a flat
blade screwdriver (Fig. 3-7). Store parts for future use.
Install the cutting attachment shield when using the
unit as a grass trimmer.
To avoid serious personal
injury, the cutting
attachment
shield SHALL be in place at all times
while operating
the unit as a grass trimmer.
Install the cutting attachment
shield on the shield
mount by inserting the three (3) screws into the shield
mount. Tighten securely with a flat blade screwdriver
(Fig. 3-7).
REMOVE
THE CUTTING
ATTACHMENT
AND
INSTALL
THE CUTTING
BLADE
NOTE: To make removing or installing the cutting
blade or cutting attachment
easier, place the unit
on the ground or on a work bench.
Remove the Cutting Attachment
Shield
See Section 3, Assembly, Remove and Install Cutting
Attachment Shield.
10