Advertisement
IMPORTANT!
Lubricating
Cams
The cams are lubricated with a sufficient amount of high-
temperature grease. To keep the attachment operating
efficiently, apply a high-temperature
grease to the cams,
and in between the yokes every 6 hours of use. (Fig. 7)
3.
Align the cams (Fig. 9).
4.
Remove the four (4) blade screws (Fig. 9).
Blade Screws
J
Yokes
/\°
J;
J
_
Cams
Fig. 7
WARNING: Failure to apply high-temperature
I
=
grease every 6 hours of operation can result
in failure Of cams and blade, and will Void
your warranty.
BLADE REPLACEMENT
NOTE: We recommend that you take the hedge trimmer
attachment to your nearest authorized service
dealer to replace the blade.
NOTE: Disconnect the hedge trimmer attachment from
the powerhead before replacing the blade.
REMOVING
BLADE
WARNING: Blades are sharpl When handling I
blade assembly, do not place your hand or
fingers between blades or in any position
where they cou d get p nched or cut.
1.
Place hedge trimmer upside down on workbench
and
remove two (2) bottom plate screws (Fig. 8).
2.
Remove bottom plate.
Bottom
Plate
Screw
.
.
-Cams
Fig. 9
Push the red end of the blade bar towards the cams.
This will loosen the blade plate so that it can be
removed easily from the cams (Fig. 10).
Fig. 10
Remove the blade by lifting and rotating it so that the
blade yokes clears the lower cam first (Fig. 11).
45° ROTATE
Fig. 11
Bottom Plate
Fig. 8
9
Advertisement
