Troy-Bilt TBHS Operator's Manual page 11

STORAGE
• Check unit before storage to be sure the equipment is
in safe working condition.
• Stop the engine or motor.
• Store the unit indoors, in a dry and locked place, out of
the reach of children.
For gas powerhead units:
• Allow the unit to cool before storing in any enclosure.
• Drain fuel from unit. Never store the unit with fuel in the
fuel tank inside a building where ignition sources are
present such as hot water and space heaters, clothes
dryers, etc.
ACCESSORIES/REPLACEMENT PARTS
Replacement Blade .................... 791-181660
Blade Screws (4 required) ............... 791-181827
Loop Handle Assembly ................. 791-180869
Handle Mounting Hardware
(4 screws, 4 nuts) ................... 791-180870
Bottom Plate ......................... 791-181849
Bottom Plate Screws (2 required) ......... 791-181827
Use only original genuine factory replacement parts.
TRANSPORTING
• Allow the unit to cool before transporting.
• Secure the unit while transporting.
For gas powerhead units:
• Drain fuel from unit.
• Tighten fuel cap before transporting.
CUTTING HEAD
Attachment Weight .............................................................. 4.6 Ibs (2.10 kg)
Cutting Mechanism ................................................................... Dual Action
Blade Length ............................................................... 16 inches (40.64 cm)
Drive Shaft Housing .................................................................... Steel Tube
11