Table of Contents
Advertisement
NOTE!
When you install the DIMM modules fully into the DIMM
socket the eject tab should be locked into the DIMM
module very firmly and fit into its indention on both sides.
WARNING!
When the DDR SDRAM CLOCK is set at 200MHz, use only
DDR400 compliant DDR Modules. When this motherboard
operates at 200Mhz, most systems will not even boot if
non-compliant modules are used because of the strict
timing issues involved, if your DDR Modules are not
DDR400-compliant, set the SDRAM clock to 133MHz to
ensure system stability.
EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
DIMM1 & DIMM3: Dual Channel 1
DIMM2 & DIMM4: Dual Channel 2
Page 14
Advertisement
Table of Contents
