Servicing The Engine Oil - Toro TimeCutter 16-42Z Operator's Manual

Servicing the Engine Oil
Check the oil level daily or after every 8 hours.
Change the oil after the first 5 operating hours and every
50 operating hours thereafter.
Oil Type: Detergent oil (API service SF, SG, SH, SJ, or
higher)
Crankcase Capacity:
* 48 oz./I-l/2 N.(1400 cc/1.41) when the filteris not
changed;
* 56 oz./1-3/4 _.(1700 cc/1.71) when the filteris
changed
Viscosity: See the table below.
USE THESE SAE ViSCOSiTY OiLS
4
mmmi
mm
mE mmm
oF20 0 20 40 60 80 100
/
--30 --20 --10 6 Jl 0 210
310 410
°C
Checking the Oil Level
1. Park the machine on a level surface, disengage the PTO,
stop the engine, and remove the key.
2. Clean around the oil dipstick (Fig. 17) so that dirt
cannot fall into the fill hole and damage the engine.
1. Oil dipstick
2. Filler tube
2X
Figure 17
3. Oil drain valve
m-6439
3. Unscrew the oil dipstick and wipe the metal end clean
(Fig. 18).
Figure 18
1. Oil dipstick 2. Metal end
1868
4,
Screw the oil dipstick fully onto the fill hole. Unscrew
the dipstick, putt it out, and look at the metal end. If the
oil level is low, slowly pour only enough oil into the fill
hole to raise the level to, but not over, the Full mark on
the dipstick.
Do not overfill the crankcase with oil
because the engine may be damaged.
Changing and Draining the Oil
1. Start the engine and let it run five minutes. This warms
the oil so it drains better.
2. Park the machine so that the drain side is slightly lower
than the opposite side to assure the oil drains
completely.
20