Before Using The First Time; Getting Started - Thermador DW244UB Care & Use Manual

BEFORE USING FORTHE FIRSTTIME
Before beginning to use your dishwasher for the first time:
1.
Check to make sure that the voltage on which the
dishwasher is to operate is the same as shown on the
rating plate.
2. Check to make sure that the water valve to the dishwasher
is open. The installer may have closed the valve upon
completing the installation.
3. Thoroughly inspect unit for cosmetic damage. Cosmetic
damage must be reported within 5 days
Figure 2. Identifying the controls
Models: DW246UB / DW246UW / DW246US* / DWI246UB / DWI246UW
On/ 011
On/Off Button
/
/
/
,/
Handle
Cycle Status Bar_
*Stainless finish will have flat anodized push-button
Pots& HeavyNormal Light Econo Rinse Rinse
Pans Wash Wash Wash Wash Only Agent
Wash
Cycle
Rinse/ Status
Dry
Hold
O o ooooo
Cycle_ Cycles
Delay\_
Hours L.ycle Delay Button
Models: DW245UB / DW245UW
Cycle Status Bar
Pots & Heavy Normal Light Rinse
Pans Wash Wash Wash Only
iOlOlOlOlOl
Cycle Cycles
Delay
Hours
Rinse
Agent
Models: DW244UB / DW244UW
Wash _ Status Bar
Rinse/_ Pots& Heavy Normal Rinse
Dry Pans Wash Wash Only
Hold
Rinse
Agent
I°1°1°1°1
Cycle Cycles
Delay
Hours
GETTING
STARTED
The operation of your Thermador dishwasher is summarized below:
1. Load the dishwasher,
Refer to Table I for items suitable for washing in the
dishwasher.The dishwasher should be loaded with pots,
pans, dishes and silverware according to the instructions
provided under the following section titled
LOADING.
2. Add detergent and rinse aid.
Detergent must be placed in the detergent dispenser
compartment as described in the following section titled
DETERGENT USE.
The use of a rinse aid such as Jet-
Dry ®
is required to ensure good cleaning and drying
results. See section titled
RINSEAID DISPENSER.
3, Check motion of wash arms,
The wash arms must be free to move and should not be
blocked by any item extending so far above lower rack
as to block upper arm or by any items hanging below
either the upper or lower rack to obstruct the motion
of the wash arms. See following section titled
.
,
Close the door of the dishwasher.
Make sure that the door is completely closed and latched.
Start the dishwasher.
If delayed start is not being selected; depress the
on/off button, then select the wash cycle desired, see Table
2, Page 11. Depress the corresponding cycle button, see
Figure 2.The light above the button will become illuminated
to indicate the selected cycle.The dishwasher will start.
NOTES:
a. If you have inadvertently depressed the
wrong cycle button, simply depress the
button of the desired cycle twice.
b. For information on how to operate the
dishwasher using delayed start see subsection
DELAYED START in following section titled
OPERATION.
6. To stop dishwasher, depress the on/off button.