Control Pad Functions - Tappan MEF352BGDA Owner's Manual

Control Pad Functions
CLEAR PAD-- Used to
clear any function
previously entered
except the time of day
and minute timer. Push
CLEAR to stop cooking.
BAKE PAD--Used to
enter the normal
baking mode
temperature.
BROIL PAD_
Used to select_
the variable
broil function.
CLEAN PAD--
Used to select the
self-cleaning
cycle.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For
satisfactory use of your oven, become fa re!liar with the va rious functions of the
oven as described below.
CLOCK PAD-- Used
UP and DOWN ARROW PADS-- Used along with the
function pads to select oven temperature, cooking
time, stop time (when programming an automatic
stop time), time of day, clean time and minute timer
day.
INDICATOR
LIGHTS-- These
light to show which
feature is in use.
OVEN, PREHEAT & LOCK LIGHTS-- The "OVEN"
light will glow each time the oven unit turns on to
maintain the set oven temperature. The "PREHEAT'
light will glow when the oven is first set to operate,
or if the desired temperature is reset higher than
the actual oven temperature. The "LOCK" light will
flash until the door locks when the self-clean cycle
is in use. It glows constantly after the door locks.
TIMER PAD--
Used to set or
cancel the minute
timer. The minute
timer does not
start or stop
cooking.
__ BAKE TIME PAD_
Used to enter the
length of the
baking time.
PAD--
Used to set the
desired stop time
for baking. Can be
used with BAKE
TIME to program a
delayed bake cycle.
The oven can be programmed to:
• Bake normally
• Time bake
• Broil
• Self-clean
For a silent control panel:
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can be programmed
for silent operation. Push and hold _. After 7 seconds, the control will beep once. This will block the controls from
sounding when a pad is pushed. To return the sound, push and hold _J again for 7 seconds until 1 beep is heard.
Note: The control will return to the audible mode after a power outage.
Temperature conversion:
The electronic oven control isset to operate in °F (Fahrenheit) when shipped from the factory. The oven can be program reed
for any temperature from 170°F to 550°F (65°C to 287°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
1. Push _. " -' appears in the display.
2. Push and hold the _ until "HI" appears in the display.
3. Push and hold _ until °F or °C appears in the display.
4. Push the _ or _to change °F to °C or °C to °F.
5. Push any function pad to return to normal operating mode.