Table of Contents
Advertisement
Setting
CIock
Minute
Timer
(some models)
Note: The Electronic
Time
of
Day clock
graphics
shown vary
by model.
f
":" Flashing
indicates
Minute Timer mode
To Set the 4 Button
Time of Day Clock
(some models)
When the range is first plugged in, or when the power supply to the range has been interrupted, "12:00" will flash in the display
window.
1.
Push @.
2.
Push in and hold O
or O
until the correct time appears in the display. O
Increases time and Ot
decreases time.
To Set the 4 Button MinuteTimer
1.
Push _,_:_wi_lappearinthedisp_aywind_w.Thetimercanbesetf_ranyam_unt_ftimefr_m_:_1
minuteto12:00
hours.
2.
Push in and hold 0
until the correct amount oftime appears
in the display. 0,
Increases
time and 0
decreases
time.
The minute timer will automatically start when the button is released. The ":" will flash to indicate Minute Timer mode.
3.
When the set time has passed, the control will display "0:00" and beep three times. The timer will continue to beep until
_or
_
is pressed at which time the timer will return to the clock mode.
Note: Push _
at any time to cancel the timer and return to the clock operation.
Always select cookware that is suitable for the amount and type of food being prepared. Select a burner and flame size
appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan.
Each burner lights automatically from either an electric ignitor or standing pilot, depending on your model. Standing pilots must
be lit initially. Refer to your installation instruction book for directions on lighting the standing pilot. Standing pilots will remain
lit when the burners are turned off. Models with electric ignitors light automatically each time a control knob is turned to the
LITE position.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings
on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wood spoons could catch fire
if placed too close to a flame.
ELECTRIC IGNITION MODELS ONLY In the event ofan electrical power outage, the surface burners can be lit manually.
To light a surface burner, hold a lit match to the burner head, then slowly turn the Surface Control knob to LITE. After burner
lights push in and turn knob to desired setting. Use CAUTION when lighting surface burners manually.
Advertisement
Table of Contents
