Advertisement
Nautilus T9 Series Treadmills
Daily
• Inspect the power cord and wal[king belt for wear,
, Check the position of the walking belt. Verify it does not rub against the frame, Evenly space the be, I t on the deck
within 0.25 inches of each side rail. Adiust the bek if necessary.
• Check the optional side hand rails. Fasten them securely.
, Remove potential hazards from the treadmill area.
Cleaning
Clean the treadmill on a regular basis he_ps to improve operation and increase component _ifespan.
Da i ly
• Keep the treadmi_ arid controller free of du_ and debris. Use a damp sponge to wipe the exteriors and walking bek.
Do not soak sudaces. DW all surfaces thoroughly.
Dry mop the deck under the belt onl[y. Do not add any lubricants--adding
lubricants can ruin the proprietary friction-
control sudace. Do not use detergents or cleaning agents on any par of the deck. Do not let liquid enter the treadmill
or controller, if it does, have a NautiBs ÷ approved technician inspect and test the equipment for safety by a before
using it again.
WeeMy
• Elevate the treadmill to maximom incline and vacuum the floor under it. This prevents excess dust and di_ from
interfering with operation.
If using the magnetic key, check it for rust: If you see rust, replace the magneL Rust en the magnetic key causes
power-up problems.
Treadmill
Integer
_
angerous voltages are present under the treadmill hood:. Use caution when performing service to the e]ectrica_
components under the hood.
Depending upon the treadmill environment, dust and or lint can a ccumu_ate under the hood. Clean the interior of the
treadmill by doing:
1. Turn the treadmill circuit breaker off. Unplug the treadmill power cord.
2. Remove the two screws on the treadmill hood.
S. Lift off the hood,
4. Cban inside the unit.
5, Reinstal_the hood and the _o screws,
6. Plug in the trea@nill power cord end switch on the trea@ni_[ circuit breaker.
Advertisement
