Sony SLV-D271P Operating Instructions Manual page 100

Turn on your TV and set it to the channel you selected in step 1 (3CH or 4CH).
The channel you selected ill step 4 appears on the TV screen. If the channels change when
you press CH +/ , you have made the correct setting.
Whenever you use the DVD-VCR, set the TV to the channel selected in step 1.
When using a 300-ohm twin lead cable for a
VHF/UHF antenna, use an antenna connector
(not supplied) to connect the antenna to the
DVD-VCR.
Loosen the screws on the antenna connector.
Wind the twin leads around the screws on the antenna connector.
Retighten the screws.
300-ohm twin
lead cable
Antenna
connector
(not supplied)
When using both a 75-ohm coaxial cable and a
300-ohm twin lead cable for a VHF/UHF
antenna, use a VHF/UHF band separator/mixer
(not supplied) to connect the antenna to the
DVD-VCR.
300-ohm twin_
lead cable _
band
separator/
mixer (not
supplied)
75-ohm coaxial cable_
Loosen the screws on the mixer.
Wind the twin leads around the screws on the mixer.
Retighten the screws.
Connect the 75-ohm coaxial cable to the mixer.
100 us
General setup information