Sony STR-DE845 Operating Instructions Manual page 14

Other Hookups
,,r
o
o
m,
=
u2
c
"o
(D
o
g
"o
o
Setting a voltage
selector
If your receiver has a voltage seledor on tile rear panel,
check that the voltage selector on the rear panel of the
receiver is set to the local power supply voltage. If not,
use a screwdriver tu set the selector to the correct position
before connecting the AC power cord to a wall outlet.
Connecting the AC power cord
Before connecting the AC power cord of this receiver to a
wall outlet:
• Connect the speaker system to the receiver (see page
16).
• Tun1 the MASTER VOLUME contro! to the leftmost
position (0).
Connect the AC power cord(s) of )'our audio/video
components to a wail outlet.
If you connect other audio/video components to the A'C
OUTLET(s) on the receiver, the receiver will supply power
to the connected component(s), allowing you to turn the
whole system or_ or off when you turn the receiver on or
off.
Caution
Make sure that the total power consumption of the component(s)
connected to the receiver's AC OUTLET(s) does not exceed the
wattage stated on the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons, fans, or TVs to
this outlet.
Note
If the AC power cord is disconnected for about two weeks, the
receiver's entire memo D' will be cleared and the demonstration
will start.
14