Sony Cyber-shot DSC-T110 Instruction Manual page 5

Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interforonce in
a residential installation. This equipment generates, uses. and can radiate radio frequency
energy and. if not installed and used ill accordance with the instructions, may cause
harmfid interference to radio communications. However. there is no guarantee that
interference will not occur ill a particular installation. If this equipment does cause harmfid
interference to radio or television reception, which can be determined by turning the
equipment off and on. the user is encouraged to try to con-ect the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase tile separation between the equipment and receiver.
Connect tile equipment into all outlet on a circuit different from that to which the
receiver is connected.
Consult tile dealer or an experienced radio/TV technician for help.
Tile supplied imerface cable must be used with tile equipment in order to comply with the
limits lk_r a digital device pursuant to Subpart B of Part 15 of F(( Rules.
G B
Notice for the customers in the countries applying EU Directives
The lniln/ifact/ll-er of this product is Sony Corporation. I-7=1 Konan Minato=ku Tokyo.
108_0075 Japan. The Authorized Representative for EM( and product safety is Sony
Deutschhmd GmbH. Hedelfinger Strasse 61. 70327 Stuttgart, Germany. For ally service or
guarantee matters please refer to tile addresses given ill separate service or guarantee
documents.
This product has been tested and lkmnd compliant with tile limits set out ill tile EMC
Directive l\)r using connection cables shorter than 3 meters (9.8 feet).
Attention
The electromagnetic ficMs at the specific frequencies may influence the picture and SO/llld
of this unit.
Notice
If static elc'ctricity or electronlagnetisnl causes datu trilnsft._r to discontinue midwa_ (fail),
restart the application or disconnect and connect tile communication cable (USB, etc./
again.
GB
5