Settin,G The Manufacturet's Code; Cable Box Or Db5 Receiver - Sony Trinitron KV-37XBR48M Operating Instructions Manual

:5'.
4
9:"
Operating a Cable Box or DBS Receiver
Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box or DBS receiver.
Press CODE SET, DBS/CABLE (FUNCTION),
the 0-9 buttons to enter the manufacturer's
code number (see the following chart), then
press ENTER.
For example, to operate a Sony DBS receiver:
FUNCTION
CODESEI Jr O_E ENTER
Manufacturer code numbers
(cable box)
Manufacturer Code
Hamlin/Regal 222, 223,224, 225,226
Jerrold/G. I. 201,202,203, 204,205,
206,207, 208, 218
Oak 227,228,229
Panasonic 219,220, 221
Pioneer 214, 215
Scientific A.t!anta 209, 2!0, 2! !
Tocom 216, 217
Zenith 212,213
34
Manufacturer code numbers
(DBS receiver)
Manufacturer
Sony
General Electric
RCA/PROSCAN
To operate the TV
Press TV (FUNCTION). Then use the TV
control buttons to control the TV.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that come
with theequipment.
Code number
801 (preset code for
remote control)
802
802
If the remote control doesn't work
• First, try repeating the set up procedures
using the other codes listed for your
equipment.
Tips "_"
• If more than o_le code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
ttour equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries -- to replace
them, for example- if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.