Setting The Manufacturer's Code - Sony Trinitron KV-27XBR45 Operating Instructions Manual

Operating a cable
jeley 4
Setting the manufacturer's code
Follow these instructions to set the manufacturer's
code which will enable you to operate a connected
cable box with the pre-programmed remote control.
For example, you can set the remote control to operate
a connected Zenith cable box as follows:
POWER (CABLE)
CODE SET
MODE
Lo asitio w position —+ JUMP
0 - 9 buttons
ENTER
CH +/-
CABLE BOX/TV
selector
1 Set the CABLE BOX/TV selector to CABLE
BOX.
CABLE BOX. .TV
2 While pressing CODE SET, press 6 and 8
(Zenith's code number —see chart on right)
and ENTER.
"8 * && &
38 Operations
3 Use POWER(CABLE) and the TV control
buttons (0 - 9, ENTER, JUMP and CH +/-) to
operate the cable converter box.
-power @O @ ©
® © ©
® ®
ENTER ©
JUMP - aN
|
ow
To operate the TV
Set the CABLE BOX/TV selector to TV. Then use the
TV control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Manufactures and code numbers (cable box)
Manufacturer
Code number
JERROLD 60, 61, 62, 63, 64, 65, 73
PIONEER 69, 70
SCIENTIFIC ATLANTA 66, 67
TOCOM 71,72
ZENITH 68
Notes
¢ If more than one code number is listed, try entering them one by one
until you come up with the correct code for your equipment.
e If you enter a new code number, the code number you
previously entered at that setting is erased.
* In some cases, your equipment may use a code that is not
provided with this remote control and you may not be able to
operate your cable box with the supplied remote control. In
this case, use the equipment's own remote control unit.
e When you remove a battery from the remote control, the code may
be erased. Reset the code each time you replace the battery, if
necessary.
¢ The JUMP button may not work or cause another function in
some cable boxes.