Snapper Z-vac 48 Assembly Instructions And Parts List page 6

Vac Unit Installation -All Models
Fit Z-Vac unit into place over and against
mower discharge, aligning holes in discharge
mounting brackets with holes in Z-Vac mount-
ing bracket. Insert discharge deflector rod,
removed in previous step, through holes and
secure with bridge pin.
Inserting T-bolt bracket into Z-Vac mounting
bracket and securing with T-bolt as shown,
align bolt plate of bracket with rear edge of
deck. Mark and drill two 7/16" holes in deck
and fasten T-Bolt bracket to deck with two 3/8-
16 x 1 cap screws and serrated flange nuts.
Vac Belt Installation -All Models
Install Z-Vac drive belt onto top tier of vac drive
pulley. Be sure belt runs through vac idler sys-
tem correctly; also be sure there is no belt
rollover.
Note: Pull back tension release lever on idler
arm (see inset) to give extra belt slack when
installing.
Belt Guard Installation -All Models
Install Vac Drive pulley guard onto bolts insert-
ed in previous step, securing with two 5/16
nylon wing nuts. Tighten securely.
6