Scotsman DCE33 Series User Manual
Restaurant type ice machine
Hide thumbs
Also See for DCE33 Series:
- Technical training manual (45 pages) ,
- User manual (44 pages) ,
- Service bulletin (4 pages)
Table of Contents
Advertisement
INTRODUCTION
The Scotsman
DCE33 is a restaurant
type ice
machine
designed
for home use. It produces
the
same high quality ice as large Scotsman
commercial
ice cube machines,
and stores that ice
in a heavily
insulated
storage
bin.
DCE33
This service
manual
is intended
as a resource
for
people installing,
using, and servicing
the DCE33.
Because
it contains
information
on safety and
maintenance,
Scotsman
strongly
recommends
that
this manual
be kept where it is readily available.
Table of Contents
Page
Technical
Information
.............................
2
Installation:
Water
...................................
3
Plumbing
..................................
4
Add On Kits:
Drain Pump
.................................
9
Door Kit
..................................
10
Reverse
Door Swing
.............................
11
Initial Start Up
................................
12
Operation
..................................
13
Component
Location
.............................
14
Maintenance
& Cleaning
............................
15
Winterizing
.................................
15
Cleaning
Ice Making System
..........................
16
Adjust Cube Size
...............................
17
Adjust Bin Ice Level
..............................
18
Adjust Timer
.................................
18
Service
Diagnosis
..............................
19
Repair:
Curtain
...................................
21
Inlet Water Valve
...............................
21
Timer
...................................
22
Cube Size Control
..............................
23
Bin Thermostat
................................
23
Water Pump
.................................
24
Parts
lists and wiring
diagrams
are located
in the center
of the manual,
printed
on yellow
paper.
This manual was printed on
August 1995
recycled paper.
Page 1
Advertisement
Table of Contents
Related Manuals for Scotsman DCE33 Series
Summary of Contents for Scotsman DCE33 Series
- Page 1 DCE33. machine designed for home use. It produces Because it contains information on safety and same high quality ice as large Scotsman maintenance, Scotsman strongly recommends that commercial ice cube machines, and stores that ice this manual be kept where it is readily available.
- Page 2 U.L., and C.U.L. Scotsman assumes no liability or responsibility any kind for products manufactured by Scotsman that have been altered in any way, including MOOeL HuMeea use of any parts and/or other components seRIALmJ}Aeen Higher BIn Ice Le'_l...
-
Page 3: Installation
115 volt dissolved by an acid cleaning, using Scotsman electricity and a drain. The machine must be installed indoors, in a controlled environment. -
Page 4: To Install: Plumbing
DCE33 TO INSTALL: Plumbing The water supply and drain should be roughed Installations on a slab: Use a pump and ready at the point of installation. A walt outlet (DCE33PA-1 B) model and pump the water to the directly behind the ice machine will make point of drainage. - Page 5 DCE33 TO INSTALL: Plumbing Free Standing Cabinet, Gravity Drain 5. Route a 5/8" ID (7/8" OD) drain tube through Model: back panel of the machine and connect to the bin drain fitting at the bottom of the bin. Secure with All horizontal runs of drain lines must have a 1/4"...
- Page 6 DCE33 TO INSTALL: Plumbing Free Standing Cabinet, Pump Model: 6. Route the plastic drain tubing to the drain point connection. Do not connect to a drain/waste line 1. Remove the kickptate and control box cover. below a trap. Connect the discharge line to the 2.
- Page 7 DCE33 TO INSTALL: Plumbing Built In, Gravity Drain Model: The drain and inlet water tubes must be plumbed 6. Push ice machine into installed position. before connecting to the ice machine. All horizontal 7. Cut off water inlet line at required length.
- Page 8 DCE33 TO INSTALL: Plumbing 9. Flush water line. Place flare nut on inlet water Built In Pump Model: line and flare the end of the copper tube. 1. Place ice machine in front of installed location. 10. Attach flare nut to the male flare on the inlet Adjust leg levelers to approximately correct water valve.
-
Page 9: To Install: Add On Kits
DCE33 TO INSTALL: Add On Kits Drain Pump Kit The DCE33 is delivered either with or without drain pump. Models without a drain pump drain their water by gravity. However, gravity drain models may be converted to Pump models thru the installation of a Drain Pump Kit and Drain Pump. -
Page 10: Door Kit
Scotsman has a stainless steel panel available fit this machine, the kit number is SS33. If the material is less than 1/4"... -
Page 11: After Installation
DCE33 AFTER INSTALLATION Reversing Door Swing: The hinged side of the door may be reversed the other side if desired: The DCE33 was shipped with the door hinged at the right. The door and hinges are designed placing the hinges on either the right or the left side of the cabinet. -
Page 12: Operation
DCE33 AFTER INSTALLATION - OPERATION How To Use: Final Check List The ice machine is extremely simple to use, just 1. Has the machine been properly uncrated, turn the ice machine control knob to the on have all packing materials and tape been removed from inside the bin? position. - Page 13 DCE33 OPERATION How does the machine make ice? Harvest: During the harvest cycle the compressor is still operating, but the spray pump and fan motor There are two distinct cycles: freeze and harvest. have stopped. Two other components have been 1 freeze cycle + 1 harvest cycle = 1 batch of 8...
-
Page 14: Component Location
DCE33 COMPONENT LOCATION Door Gasket Curtain Reservoir Thermostat Bracket Control Box Control Knob Cover Kickplate August1995 Page 14... -
Page 15: Maintenance
DCE33 MAINTENANCE AND CLEANING What shouldn't be done? How to clean the condenser. The condenser is like the radiator on a car, it has Never keep anything in the ice storage bin that is not ice; objects like wine or beer bottles are not fins and tubes that can become clogged. - Page 16 3. Pour 4 ounces of Scotsman Ice Machine Cleaner (available from a local Scotsman Distributor or Dealer, ask for part number 6. Pour hot (95UF. - 115UF.) water into the bin to 19-0343-06 - an 8 ounce bottle) into the ice machine reservoir.
- Page 17 DOE33 ADJUSTMENTS There are three items that may be adjusted: Cube Size, Harvest Time, and Bin Level. Note: Cube Size and Harvest Time adjustments should only be done by a qualified service person. SIDE VIEW OF CUBES Cube size control. The cube size control should only be adjusted to bring the cubes to the correct shape, the overall size cannot be adjusted.
- Page 18 DCE33 ADJUSTMENTS Bin's ice level. Timer. When the ice machine shuts off the ice level in the The amount of harvest time may be adjusted. It is bin should be even with the metal tube inside the preset from the factory at about 3 minutes, which bin.
-
Page 19: Service Diagnosis
DCE33 SERVICE DIAGNOSIS PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION The machine does not operate The machine is unplugged Plug the machine Breaker tripped or fuse is blown. Reset breaker/replace fuse - if it happens again, call for service to check for a short circuit in the machine. - Page 20 DCE33 SERVICE DIAGNOSIS PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION No ice falling in bin, but machine Ice may be stuck in the Check water supply - filter may be restricted operates evaporator and the unit is "frozen up". Check inlet water valve - screen may be restricted, or valve does not operate.
-
Page 21: Curtain
DCE33 REPAIR Inlet WaterValve kWARNING The inlet water valve may need to be cleaned replaced. If there is not enough water coming into Electrical Shock Hazard the machine, the valve may need to be cleaned. Disconnect Electrical the valve does not work at all, or does not shut off Power Before Beginning tightly, it should be replaced. -
Page 22: Timer
DCE33 REPAIR &WARNING Electrical Shock Hazard Disconnect Electrical Power Before Beginning Removal of Parts Timer The timer may need to be replaced if it does not turn, or if it turns and then stops (except at the end of the harvest cycle - the timer will ALWAYS stop at the end of the harvest... -
Page 23: Cube Size Control
DCE33 REPAIR Bin Thermostat kWARNING The bin thermostat is the automatic on-off control for the ice machine. Electrical Shock Hazard 1. Unplug or disconnect the electrical power to the Disconnect Electrical ice machine. Power Before Beginning 2. Pull the machine out from its installed location. -
Page 24: Water Pump
DCE33 REPAIR Spray Jets kWARNING Spray Jets are small nozzles that are under the freezing surface, they spray a narrow pattern of Electrical Shock Hazard water at the freezing surface. If plugged Disconnect Electrical restricted, poorly shaped ice cubes will form. Power Before Beginning If the spray jets are removed the o-rings...