Sanyo DS27820 Owner's Manual page 14

QuickTips
: [] PIP window is black
with no picture:
1. Check cable
connections.
2. Make sure VCR is
turned on.
3. Select another
channel on your VCR.
[] Same picture appears
in Big and Small
windows. Set VCR
m TV mode.
: [] 7b view two TV
programs or wat¢]7
a TVprogram and
prerecorded tape at
file same time, fi)llow
steps on this page and
chart on pa,qe 15.
PIP KEYS
: [] Use the SWAP key w
erchange programs
between the windows.
: [] Use the LOCATION
key to change the
position o[ the small
window (Top: L/R or
Botwm: L/R).
i [] Use the
QUiK
FREEZE
k:Ly to stop the
action (see page 15).
:[]Use the SELECT key
ro choose the PIP
video source (Video l,
Video2, or TV RF
Signal).
Needhelp?
Visit our Website at
www.sanyoc|v.com
or Call1-800-877-5032
PICTURE-IN-PICTURE (PIP) OPERATION
For PIP to function you must connect two signals to the TV. (Use the TV's 75 ohm input
and A/V inputs.) Connect VCR (or other accessory equipped with a video output jack) to
the TV's audio video jacks as shown on pages 12 and 13. If you are using a satellite dish,
you must connect a cable system or antenna with the satellite to use the PIP feature. For
operation with Cable Box, see chart on page 15.
USING PiP TO ViEW TWO'IV PROGRAMS
Note: The following steps correspor_d to rmmbers or_ the Remote Corffrol art below.
1. Switch VCR and television ON.
2. Press PIP ON/OFF key.
Set VCR to TV mode, if necessary.
3. Select channel for big window.
4. Press SELECT key to select Videol or Video2 screen.
S. Press VCR key.
Note: If the remote control cannot be programmed to
operate your VCR, you must use the VCR's remote
to perform VCR functions.
6. Select channel on VCR for small window.
USING PiP TO VIEW TV PROGRAM
AND PRERECORDED TAPE
Note: The following steps do not have corresponding
reference numbers on the remote control art.
1. Set TV channel to match output of VCR (Channel 3 or 4).
2. Insert prerecorded tape into VCR.
3. Press PLAY, if necessary (wait for tape to load).
4. Set VCR to TV mode.
Note: When the remote control is in the VCR mode, the
INPUT key works like the TV/VCR key
on the VCR.
VCR set to VCR mode.
Same image appears in
both windows.
VCR set to TV mode.
Different images appear
in each window.
5. Press SWAP
key to view PIP image in big window.
Platy
B _ M
/