Table of Contents
Advertisement
I
INSTALLATION
Connecting
a Second
VCR
to
Record
from
the
TV
Your TV
can send
out signals
of its picture
and sound
to be recorded
by a second
VCR. To do
this,
connect
your
second
VCR as follows:
Connect
a set of audio cables between
the AUDIO OUTjacks on theTV and the
AUDI0 !ajacks on the VCR:
(The
VCR input jacks might be either
TV Rear Panel
Connect
a video cable between
the
VIDEO
OUTjackon
the TV and the
VIDEO INjack
on the VCR.
Refer
to your VCR's instructions
for
more
information
@bout how to record
using
this kind
Of connection.
Video/Audio Cable
Connecting
a Camcorder
The fiont panel jacks on your TV make it easy to connect
a camcorder
to your TV. They allow
you to view the carncorder
tapes without
using a VCR. (Also see "Selecting a Signal Source
(External A/V)" on page 3.21)
1
Locate the A!V outputjacks on the
ca _corder, They are usually found on
the side or rear of the camcorder,
TV Front Panel
2
Connect an audio cable between
the
AUDIO OUTPUT lack on the camcorder
and the AUDIO terminals
on the front of
the TV
If you have mono
camcorder,
connec[
L mono_
ro camcorder
audio
our using
_nly one audio
'able.
Videu/AudiO Cable
Connect a video cable between the
VIDEOOUTPUTjack on the camcorder
and the VIDEOterminal on the front of
the TV
]-he audio-video cables shown here are
usually included with a Camcorder. (If'
not.
check
your
local
electronics
store.,
If' your camcorder is stereo,you need to
2OrKlec_
a se[
of
two
cables.
Note: This figure shows the Standard Connector-jack pane!. The actual configuration on your TV may
be different, depending on the model.
OIIAPTER
TWO:
]NSTA[IAT[ON
2.6
Advertisement
Table of Contents
