Emptying The Dust Cup - Eureka 5740 series Owner's Manual

The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust
cup, filters, belt, and brush roll often. We suggest emptying the dust cup after every use.
NOTE: When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances,
the dust cup and filters will require more frequent maintenance.
NOTE: Turn off the switch and unplug the electrical cord before changing the filter. Never operate the
vacuum cleaner without the dust cup or filter assembly in place.

Emptying the Dust Cup:

1 Remove dust cup by pulling latch upward and
pivoting dust cup out and away from cleaner.
3 Lift filter up and out of dust cup with a twisting
motion.
Reinstalling the Dust Cup:
1
Replace filter onto center tube in dust cup applying gentle pressure.
Line up tabs on dust cup with openings on lid, rotate
lid clockwise while applying pressure to secure. The
2
lock symbol ( ) on lid will be centered over dust cup
handle when properly assembled.
3
To replace dust cup, position dust cup with handle facing inside the dust
cup compartment; place bottom of dust cup in bottom of compartment and
rotate upward, pushing dust cup against cleaner until it locks into place.
10
2
Grasp dust cup lid and twist counterclock-
wise to remove.
Dump debris in a waste container.
4
Tab
Tab
2