Page 1
G G u u í í a a d d e e l l P P r r o o p p i i e e t t a a r r i i o o Before Returning, Call Eureka Customer Service Antes de enviar de regreso, Ilame al Servico al Cliente de Eureka HELPLINE LÍNEA DE AYUDA 1-800-282-2886 8 a.m.
Eureka vacuum cleaner. Inspection Carefully unpack and inspect your new Eureka vacuum cleaner for shipping damage. Each unit is tested and thoroughly inspected before shipping. For instructions regarding any shipping damage, call Eureka Customer Service HELPLINE 1-800-282-2886 immediately.
If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Motor Do Not Oil the motor or the brush roll at any time. The bearings are permanently lubricated and sealed. Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com...
LINE UP DOOR LOCK & & TO REMOVE DOOR REMOVE CARTRIDGE PRESS FIRMLY TO LATCH BRUSH ROLL – Clean monthly Brush Roll Cogged Belt COGGED BELT – Replace a worn or broken belt 2 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com...
Make sure vacuum is below you, pushed against the bottom step. 1) If model has additional stair hose, attach to end of hose. 2) Attach turbo nozzle to the end of wand and hose. Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com...
Fig. 6 screws (Fig. 6). Brush Roll Reset Button 1) Clear interference that caused brush roll to stall. 2) Press reset button on the side of vacuum below brush roll cover (Fig. 7). Fig. 7 www.eureka.com Eureka Customer Service HELPLINE 1-800-282-2886...
1) Remove 6 screws and brush roll cover (Fig 5). 2) Clear blockage from base hose (Fig. 6). Check for debris in brush roll and clean if needed. 3) Replace 6 screws and brush roll cover. Fig. 5 Fig. 6 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com...
What Eureka Will Do Your relief for the breach of this warranty is limited to Eureka will, at its option, repair or replace a defective the relief expressly provided above. In no event shall vacuum or vacuum part that is covered by this warranty.
30 minutes before attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and turn on the switch. If the vacuum still does not work, take it to a Eureka authorized service center for repair or call 1-800-282-2886.
Need help?
Do you have a question about the 5890 Series and is the answer not in the manual?
Questions and answers