Advertisement
SmartSet Technical Reference Manual—Addendum for the E281-2310 Controller
page 93
page 95
page 97
page 98
page 99
page 102
page 104
page 108
page 109
page 110
page 112
byte:
Features
Bit 7 is 1 - Z-axis available.
is a bitmap specifying which option jumpers are installed:
X1
X1 Bit Position
0
1
2
3
is a bitmap specifying whether cross-connected jumpers are
X2
installed:
X2 Bit position
0
1
2
Not supported.
Not supported.
:
Mode1
Bit
6
7
:
Mode2
All bits reserved (0).
Not supported.
Not supported.
Not supported.
Hard Reset Command: If the host cannot monitor -CTS,
approximately 5 seconds should be allowed for the reset procedure
to take place.
Not supported.
Set or query commands are not supported. Touch packets are
generated automatically.
Description
J0 installed
J1 installed
J2 installed
J3 installed
Description
jumper connects J0 to J1
jumper connects J1 to J2
jumper connects J2 to J3
Description
Reserved (0)
1 - Z-axis Enable
8
Advertisement
