Advertisement
SmartSet Technical Reference Manual—Addendum for the E281-2310 Controller
Serial Controller Installation
This section assumes you are integrating the E281-2310 serial controller board
into your system as a component.
The following information gives you mounting dimensions, touchscreen
connections, power connections and requirements, and data output connections. It
is your responsibility to determine how best to mount the controller and data
connector in the display or separate enclosure, and provide a power supply.
Mounting the Controller and Connecting Chassis Ground
The mounting dimensions for the E281-2310 controller are shown in Figure 1,
page 1. Remember that the cable headers will increase the space required.
The mounting holes fit common 0.156 inch plastic snap-in standoffs. A chassis
ground connection is required through one of the plated through mounting holes
(PTH) or P4 pin 8 to provide adequate shielding for the touchscreen cable.
Conductive mounting hardware can provide a chassis ground connection for the
controller.
Serial Controller Connections
Power Connections
The E281-2310 controller operates on a single voltage, positive with respect to
ground. See page 10 for power requirements.
Connect a power cable harness to P4 on the controller, a 2x5 header with pins on
0.100" centers. Use a ribbon cable with an IDC connector or crimp-to-wire pin
receptacles. An acceptable plug can be selected from Molex series 70450, Amp
AMPMODU Mod. IV product line, or Berg mini-latch housing with Mini-PV pins.
Connect a power supply to the harness and then to AC.
Figure 2. P4 Power Supply Connector Pin Positions, End View
9
7
5
3
1
·
·
·
·
·
·
·
X
·
·
10
8
6
4
2
2
Advertisement
