Advertisement
SmartSet Technical Reference Manual—Addendum for the E281-2310 Controller
Physical Characteristics
Construction
Four-layer surface-mount design with internal ground plane for EMI suppression.
Dimensions
See Figure 1, page 1. Total height including shield less than 0.75".
Mounting Hole Dimensions
See Figure 1, page 1. Two mounting holes are plated through-holes (PTH) for
chassis ground connection.
Connectors and Pin Definitions
The connector configuration permits the controller to be placed in-line between the
touchscreen and serial I/O attachments.
Serial Input/Output Connector
2x5 0.025" post latching header on 0.100" centers. Acceptable mating insulation
displacement connectors (IDC): Berg series 71600, 71602, 66900, 66902, Molex
series 40312, Amp series 746285 and 746288. When the mating IDC receptacle is
cabled to an IDC DB9 connector, the interface assumes a DCE configuration.
Touchscreen Connector
2x6 0.025" square post friction lock header on 0.100" centers. Mates with Berg
Mini-Latch receptacle on the IntelliTouch touchscreen cable. The withdrawal force
exceeds 3.9 lb.
Power Connector
2x5 0.025" square post friction lock header on 0.100" centers. Acceptable mating
receptacle connectors: Molex series 70450, Amp AMPMODU Mod. IV product
line, or Berg mini-latch housing with Mini-PV pins.
12
Advertisement
