Table of Contents
Advertisement
FEATURES AND MENUS
PIP
(PICTURE-IN-PICTURE)
OPERATION
The PIP (picture-in-picture)
feature lets you display a second, smaller
picture on top of the main picture.
Your TV is equipped with a single tuner that tunes to cable or off-air
television signals. The PIP feature on your TV requires a second video
source, like a VCR or satellite receiver to supply the second picture, to
the scre'en. The PIP fe'ature also requires connecting the second vide{>
source to the TV with audio/video cables.
PIP BUTTONS
There are four remote buttons that control the way the PIP window
works:
PIP Brings up the PIP window. Press PIP again to remove the window.
When PIP Caption Display - Alternate with PIP - has been selected,
will display captioning in the PIP window.
MOVE buttons Let you move the PIP window to different areas of the
screen.
SWAP Switches, or "swaps," the video from the PIP window with the
main picture.
CH CTRL (Channel Control) Lets you switch channel control between
the PIP window and the main picture.
USING
THE
PIP
FEATURE
While you may use PIP in different ways, this basic PIP scenario
should get you started. While watching the TV, folk>w these steps to
use your VCR to supply the picture for PIP.
1.
Pressthe PIP button on the remote. The PIP window appears on
the screen.
2.
Turn on theVCR.
3.
Pressthe TV button, then press WHO-INPUT
until you see the
VCR signal displayed in the PIP window. The PIP window should
display the channel that you have the VCR tuned to.
4.
At this point, in order to change the program in the PIP window,
you need to change the channel on the VCR because that is the
signal source for the PIP picture.
5.
Use the channel
up and down buttons
and the other PIP buttons,
MOVE,
SWAP and CH CTRL to adjust the two pictures.
_w
vc_
_ux S_,CAB[E
&oA
A
--Move
buttons
PIP buttons
A typical
use of SWAP is to scan through
channels
in the PIP window,
and when
you find a channel
you like, press SWAP
to display
that channel
in the main
picture,
sending the current channel
to
the PIP window.
You must change the mode between the
TV and VCR after every SWAP.
37
Advertisement
Table of Contents
