Placing Channels; Using A Dvanced Features - RCA F19202 User Manual

Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
1. Place channels in
memory (AutoProgram)
Controls Alarm Ad
13
A.
g.
Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memorl.
Press MENU on the TV front
panel repeatedly to select the
Setup Menu and highlight
Autoprogram. This menu is
white.
C. Press + to start the TV adding
all active channels into
memo_1.
D. Wait until the TV has cycled
through all the channels and
returns to the original channel.
E.
Press DISPLAY to remove the
menu from the screen when
you are finished.
2. Add or delete channels
Controls Alarm Ad
Controls Alarm Adjust
13
13
A. Press MENU on the TV front
panel repeatedly to select the
Setup menu. This menu is white.
B. Press CHANNEL down to
highlight Channel Memory.
C. Press + to underline the channel
number.
D. Select the channel number you
want to add or delete with the
number buttons.
E. Press + to add or delete a
channel (you will see Stored on
the screen when added and
Erased when deleted).
F. Repeat D and E for more
channels.
G.
Press DISPLAY to remove the
menu from the screen when you
are finisihed.
11