Table of Contents
Advertisement
the
Re Qte
C@ntr@J
Tip
To turn off all the
RCA, GE, and
PROSCAN
components
that are
connected
to the T_,
press ONoOFF twice
within
two seconds
This feature
only
works with most RCA,
GE and PROSCAN
products
PAUSE If you're operating
a VCR or DVD Player with tile remote cnntrnl, press PAISE when the disc
or videotape
is playing to pause playback.
PLAY If you're operating
a VCR or DVD Player, plays the disc or videotape.
REC-VCR+
When tile GLIDE Plus+ program
guide is on the screen, press RECoVCR+ to program
your VCR to record a program.
If the remote is in VCR mode, press RECoVCR+ to start recording.
llEVERSE
If you're nperating
a VCR or DVD Player with the remote control, press REVERSE to go
backwards
on a disc or videotape.
SAT.CABLE
Puts the remote in SKI'oCABLE mode.
If you set tip tile Auto Tuning l_,ature (Chapter
3), pressing tile SKI'-CABLE bu/lnn automatically
tunes the TV to the correct channel.
SKIP
If you press this button bel_>re you change the channel,
tile TV waits 30 seconds
and
automatically
goes back to the original channel. Each time you press SKIP, you add 30 seconds
(i.e, if
you press SKIP two times bet_>rc you change tile channel, tile TV wails 60 seconds
and automatically
turns back to the original channel).
SOUND
Displays tile AtJ)IO
I:'ROCt_.SSORmenu.
STOP If you're operating
a VCR or DVD Player, slops playing the disc or videntape.
TV Turns on tile TV and puls tile remote in TV mode. Also displays channel inl_>rmatinn.
VCR1 Puts the remote in VCR mode. If you set up tile Auto Tuning I_.ature (Chapter 3), pressing the
VCR1 buuon automatically
tunes the TV lo the cnrrect channel.
VCR2 Puls tile remote in VCR mode. If you set up tile Auto Tuning fi.ature (Chapter
3), pressing tile
VCR2 butlon automatically
tunes the TV lo the cnrrect channel.
VOL (up and down)
buttons
Decrease or increase tile TV's volume.
WHO.INPUT
In TV mode, press WHOoINPUT
to toggle through tile awtilable Video Input channels
(VIDiSVID and the current channel).
In SKI"mode, press to select available channel
lists.
Using the WHO-INPUT
Button
Use the WHOoINPUT
button to toggle through the available input sources (VID and the current
channel)
and view tile content t_nm the component
you have connected
to tile TV.
1.
Press TV to place the remote in TV mode. Make sure that the content from the component
is
turned ON.
2.
Press WHOoINPUT
to tune to the awtilable input source and view the component.
3.
Press WHOoINPUT
again to tune back to tile channel you were previously
walching.
25
Advertisement
Table of Contents
