Table of Contents
Advertisement
C nnections
Setup
Step 3: Configuring
for a VCR
1.
It your TV is connected
to a VCI,', press OK.
It it is not, highlight _,_band press OK (a screen will appear reminding
you
to connect your G-LINK cable to your TV and VCR.).
2,
l_se the kip and dov_,n arrow buttons to highlight tile brand nt your VCR that
is connected
to the TV and press OK.
It your brand isn't listed, highlight Not Listed and press OK.
,
Tune your VCR to channel 02. Next, turn OFF your VCR. When you
complete
these steps, press OK to begin testing.
lmportant
Note:
When code testi_zg is in pro/gress, don't toz_ch yoz_r TK
VCR, or a_, (f tbe remole control._ jbr tbese products.
4,
Look at the front
display
of your VCR. If your VCR turned
on automatically
and
changed
to channel
09, tile test was successful.
Highlight
Yes and
press
OK.
It your VCR didn't change to channel 09, you can either choose 3tb or Test
this code again.
If you think your TV or remntes
might have been touched
during the test,
rune your VCR to channel 02, mm nit your VCR and highlight
7},st this
code a<,ga#z.
If you don't think the test was interrupted,
highlight 3,b, Tune your \ CR to
.
)
+
channel 02 and ttlrn nit your VCR. Press OK (tile G{ Ir)E t lus
system starts
testing another set nt codes.)
Keep
Ik)llnwing
the previous
instructions
until the VCR finds
the
correct
code.
20
Chapter
f
Advertisement
Table of Contents
