Error Messages; Messages D'erreurs; Fehlermeldungen - Electrolux Trilobite Overview Manual

Normal. Timer: Auto
Select start time?
21. Repeat the programming steps for any
other days you want cleaning to be out.
22. Press "On/Off" button and place it in the
charger.
When Trilobite is placed in the charger and
a cleaning program is active, a clock symbol
is displayed. (Trilobite will now clean on the
set time.) NOTE: If batteries are not fully
charged at set start time, the cleaning start
will be skipped or delayed up to one hour.
To activate Trilobite:
1. Start Trilobite.
2. Press until "Select start time"
is displayed.
3. Press .
4. Press to select "Enable".
5. Press to activate the cleaning program.
To deactivate Trilobite:
1. Start Trilobite.
2. Press until "Select start time"
is displayed.
mreri
3. Press .
m
4. Press to select "Disable".
5. Press to deactivate the cleaning
5,
program.
alla
To remove a cleaning program:
1. Start Trilobite.
2. Press until "Select start time"
is displayed.
3. Press .
4. Select "Timetab.".
5. Press .
6. "Select start day" is displayed.
7. Press until the day is displayed on
which you wish to remove the cleaning
program.
On days with cleaning set, the start time is display-
ed; otherwise "—:—" is displayed.
8. Press "Select start time" is displayed.
9. Press until "—:—" is displayed.
10. Press .

Error Messages

Error: 7
Check
the bumper
See manual
Error Messages
The only faults that you can rectify yourself
are the ones listed below. In the event of
other error messages, recharge and restart
your Trilobite. If it still does not start, contact
our Customer Service, see page 18.
The errors you can correct yourself are
presented below:
5. Check roller.
Is something stuck?
Is it incorrectly attached?
6. Check casters.
Is something stuck?
7. Check bumper.
Verify its spring action. Is something
stuck preventing it from moving?
12. Trilobite is stuck.
Move it and switch it on again. Also see
Normal Vacuuming on page 5.
15. Check dust cassette.
In most cases, the filter unit has probably
not been set or it is incorrectly set.
16. Check charger.
Is the charger connected to the mains?
Are the terminals on the charger and
Trilobite properly connected to each
other?
21. Moisture on the circuit board.
Let the machine dry out for 12 hours.
Then try restarting it.
English 13