Dialing With Multilink Ppp - Farallon NetopiaTM User Manual

42 Chapter 5
6. Enable at least one of the Desired Protocols (e.g., IP or IPX),
then select OK.
7. Back in the Connect screen, enter your user name, password,
and the phone number to be dialed, then select Connect.
8. If the connection was successfully completed, you can com-
municate with the remote host.
If the connection could not be established, verify your configu-
ration and TCP/IP settings, and alter them as required.
D M
IALING WITH
If you intend to establish a Multilink PPP connection, contact your
Information Services department or Internet Service Provider to
ascertain whether you will need one or two remote numbers to
properly set up both B-channels.
To establish a Multilink PPP connection, each B-channel requires
a remote directory number to connect to. Depending upon your
ISDN implementation, the two numbers may differ, or be identical.
If the numbers differ, the "~" or "&" character must be used to
separate the numerical strings on the dial line. Otherwise, only a
single number is input to connect both B-channels.
PPP
ULTILINK