Zanussi ZBB5286 User Manual page 9

Problem
There is too much frost.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Press on the rear hook and at the same time slide the
cover in the direction of the arrow.
3. Replace the bulb with one of the same power and
specifically designed for household appliances. the
maximum power is shown on the light bulb cover)
4. Replace the light cover by sliding it into its original
position.
5. Reconnect the appliance.
6. Open the door and check if the light comes on.
Possible cause
Food is not wrapped correctly.
The door is not closed correctly.
Wrap the food correctly.
Refer to "Closing the door".
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
Solution
9