Zanussi ZBB5286 User Manual page 12

x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance as
shown in figure.
I
I
Attach the appliance to the
niche with 4 screws.
12
x
A
Drill the hinge cover A, as
shown in figure.
Apply the covers A and A1
(in the accessories bag) in
to the middle hinge.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of right
hinge, SX in opposite case.
A1
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
C
D
E
E
Attach the covers (C, D)
to the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
2
4mm
1
44mm
Adjust the appliance in the ni-
che.
Make sure that the distance
between the appliance and the
cupboard front-edge is 44
mm.
The lower hinge cover (in the
accessories bag) makes sure
that the distance between the
appliance and the kitchen fur-
niture is correct.
Make sure that the clearance
between the appliance and the
cupboard is 4 mm.
Open the door. Put the lower
hinge cover in position.
E
B
E
If the appliance must connect
laterally to the kitchen furni-
ture door:
1. Slacken the screws in fix-
ing brackets (E).
2. Move the brackets (E).
3. Retighten the screws.