Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZBB5286
Summary of Contents for Zanussi ZBB5286
- Page 1 User manual Fridge-Freezer ZBB5286...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... - Page 3 or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance.
-
Page 4: Control Panel
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. -
Page 5: Daily Use
Daily use Freezing fresh food Important! Do not use metallic instruments to remove the trays from the freezer. The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. Movable shelves To freeze fresh food activate the Action Freeze function at least 24 hours before placing the food to be frozen in the The walls of the refrigera- freezer compartment. -
Page 6: Care And Cleaning
• do cover or wrap the food, particularly if it has a strong • wrap up the food in aluminium foil or polythene and flavour make sure that the packages are airtight; • position food so that air can circulate freely around it •... -
Page 7: What To Do If
er. This operation will improve the performance of the ap- Defrosting of the freezer pliance and save electricity consumption. The freezer compartment of this model, on the other hand, is a "no frost" type. This means that there is no buildup of Important! Take care of not to damage the cooling system. - Page 8 Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The lamp does not operate. The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly.
- Page 9 Problem Possible cause Solution There is too much frost. Food is not wrapped correctly. Wrap the food correctly. The door is not closed correctly. Refer to "Closing the door". Replacing the bulb Closing the door If you want to replace the bulb, do these steps: 1.
-
Page 10: Technical Data
Technical data Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 13 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. - Page 11 As the colours of the wires in the mains lead of this appli- 6. Switch on the appliance. ance may not correspond with the coloured markings The appliance is supplied with a 13 amp plug fitted identifying the terminals in your plug, proceed as follows: In the event of having to change the fuse in the plug sup- plied, a 13 amp ASTA approved (BS 1362) fuse must be 1.
- Page 12 44mm Drill the hinge cover A, as Install the appliance in the Adjust the appliance in the ni- If necessary cut the adhe- shown in figure. sive sealing strip and then niche. che. Apply the covers A and A1 Push the appliance in the Make sure that the distance apply it to the appliance as (in the accessories bag) in...
-
Page 13: Environmental Concerns
ca. 50 mm 8 mm 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the Open the appliance door and Install the part (Ha) on the part (Ha). the kitchen furniture door at Disconnect the parts (Ha), inner side of the kitchen an angle of 90°. - Page 16 www.zanussi.com/shop...