Table of Contents
Advertisement
Operating sequence
When the programme has finished, the «End»
pilot light illuminates and in the same time the
light of the button
6
left in the tub, the «Door» light illuminates but
the door remains locked.
The «Door» pilot light indicates if the door can
be opened:
• light on: the door cannot be opened.
The appliance is operating or there is water
left in the tub. Attention! If the door is locked
do not try to open it!
• light blinking: the door is opening.
• light off: the door can be opened.
The washing programme has finished.
Altering an option or a running programme
It is possible to change a few options before
the programme carries them out.
Before you make any change, you must pause
the washing machine by pressing the button
.
6
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «Off» and then to the new
programme position. Start the new programme
by pressing the button
The washing water in the tub will not emptied
out.
Interrupting a programme
Press the button
6
which is running, the corresponding light starts
to flash. Press this button again to restart the
programme.
Cancelling a programme
Turn the selector dial to Off to cancel a
programme which is running. Now you can
select a new programme.
goes off. If there is water
again.
6
to interrupt a programme
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
.
6
If the door light starts blinking and goes off
after some minutes, the door can be opened.
If this light remains alight after some minutes,
this means that the machine is already heating
or that the water level is too high.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After a few
minutes the door can be opened (pay
attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button
.
6
At the end of the programme
The machine stops automatically. On the
display will appear a flashing «
door can be opened.
If the «Rinse hold» or «Night Cycle» option
has been selected, the display will show a
flashing «
» but the door remains locked
0.00
to indicate that the water must be emptied out
before opening the door.
To empty out the water proceed as follows:
1.turn the programme selector dial to «Off»
2.select the Drain or Spin programme
3.reduce the spin speed if needed, by pressing
the relevant button
4.press the button
6
programme
5.at the end of programme, only the «End»
light illuminates. Now it is possible to open
the door.
» but the
0.00
to start the selected
17
Advertisement
Table of Contents
