Table of Contents
Advertisement
Operating sequence
Heating phase
the heating phase of the water in the tub.
Start the programme by pressing the button
6
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
The «Wash» and «Door» lights illuminate to
indicate that the appliance starts operating and
the door is locked.
To interrupt a programme which is running,
press the button
: the corresponding green
6
pilot light starts to flash. To restart the
programme from the point at which it was
interrupted, press this button again.
If you have chosen a delayed start, the
machine will begin the countdown.
IMPORTANT!
If an incorrect option is selected, the red pilot
light of this button flashes for 3 times and the
message Err is displayed for a few seconds.
Select the Delay Start by pressing the
button
8
Before you start the programme, if you wish to
delay the start, press the button
to select the desired delay.
The selected delay time value (up to 20 hours)
will appear on the display for a few seconds,
then the duration of the programme will appear
again.
You must select this option after you have set
the programme and before you press the
button
.
6
16
During the washing
cycle the display shows
a temperature icon to
indicate that the
appliance has started
repeatedly,
8
Selecting the delayed start:
Select the programme and the required
●
options.
Select the delay start.
●
the button
: the machine starts its
6
●
countdown.
The programme will start after the selected
delay has expired.
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the button
If you have already pressed it, and you wish to
cancel the delay time, proceed as follows:
• set the washing machine to PAUSE by
pressing the button
• press the button the button
until the symbol 0' is displayed.
• press the button
6
programme.
IMPORTANT!
• The selected delay can be changed only
after selecting the washing programme
again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button
goes off after a few minutes and the door can
be open. After you have closed the door,
press the button
6
The Delay Start cannot be selected with
Drain programme.
Programme progress display
After having pressed the button
«Wash» pilot light illuminates and stays on
while the machine is working. At the end of
any cycle it goes off.
.
6
;
6
repeatedly
8
again to start the
. The «Door» light
6
again.
, the
6
Advertisement
Table of Contents
