Chapter 3 Wireless Lan Access Point Configuration; Getting Started - Edimax Wireless LAN Access Point User Manual

Chapter 3 Wireless LAN Access Point
3.1

Getting Started

This Access Point provides web-based configuration tool allowing you to configure
from wired or wireless stations. Follow the instructions below to get started
configuration.
From Wired Station
1. Make sure your wired station is in the same subnet with the Access Point.
The default IP Address and Sub Mask of the Access Point is:
Default IP Address: 192.168.2.1
Default Subnet: 255.255.255.0
Configure your PC to be in the same subnet with the Access Point.
1a) Windows 95/98/Me
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel
window will appear.
2.
Double-click Network icon. The Network window will appear.
3.
Check your list of Network Components. If TCP/IP is not installed, click the Add button to
install it now. If TCP/IP is installed, go to step 6.
4.
In the Network Component Type dialog box, select Protocol and click Add button.
5.
In the Select Network Protocol dialog box, select Microsoft and TCP/IP and then click the
OK button to start installing the TCP/IP protocol. You may need your Windows CD to
complete the installation.
6.
After installing TCP/IP, go back to the Network dialog box. Select TCP/IP from the list of
Network Components and then click the Properties button.
7.
Check each of the tabs and verify the following settings:
Microsoft Networks.
Configuration
Bindings: Check Client for Microsoft Networks and File and printer sharing for
Gateway: All fields are blank.
DNS Configuration: Select Disable DNS.
WINS Configuration: Select Disable WINS Resolution.
Wireless LAN Access Point Configuration
6