Installingyourcompactor; Unpacking Yourcompactor; Locationrequirements - Whirlpool 800 SERIES Use & Care Manual

InstallingYourCompactor
IMPORTANT:
Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and for
local electrical inspector's use, if required.
Unpacking YourCompactor
IMPORTANT:
• Do not grasp console to move compactor.
• Begin in the room where the compactor will be
located.
1. Remove compactor from shipping carton. Remove
all protective packaging materials such as tape and shipping
pads. Remove waxy residue caused by protective shipping
material with a mild solution of liquid household cleaner and
water.
2. Check that power supply cord is attached to the cord clip on
the rear of the compactor.
cord
clip \
I
m
3. Place two corner posts from carton on floor near compactor.
Open compactor drawer and remove any shipping materials
or other items shipped in the drawer. Do not remove the
compactor bag (if installed). Grasp the handle and raise the
front of drawer until it clears the drawer stops, Grasp sides of
drawer and lift drawer out of compactor. Place the drawer on
the two corner posts.
m
m
Excessive Weight Hazard
Use two or more people to move and install
compactor.
Failure to do so can result in back or other
injury,
4. Place the other two corner posts on the floor to the side of
the compactor. Grasp the sides of the compactor cabinet and
put compactor on its side on top of the corner posts. Remove
the shipping base from the bottom of compactor.
leveling legs
LocationRequirements
Check the location where your compactor will be installed. The
cabinet opening should be square. You should be able to fully
open the compactor drawer. Six inches (15.2 cm) of clearance is
needed on the right side of compactor drawer to be able to
remove compactor bag. Allow 23 inches (58.4 cm) in front of the
compactor to remove drawer.
Product dimensions
The overall lookof your compactormay vary,
34_"
186.7_m)
24"
(38.1 cm) (61 cm)
5