Cooling On/Off - Whirlpool WRF989SDAW0 Use & Care Manual

View Temperature Set Points
1. Press and hold TEMP for 3 seconds to activate Temperature
mode.
NOTE: To view temperature in degrees Celsius, press the
LIGHT button, under Units, when adjust mode is activated. To
return the display setting to Fahrenheit, press the LIGHT
button again.
When Temperature mode is activated, press TEMP to toggle
between Fridge and Freezer. The display will show the
temperature set point of the selected compartment, and
temperature adjusting information will appear on the display
screen.
Recommended Refrigerator Temperature
FRIDGE
RECOMMENDED
--I
--I
°F
El I
BACK UNITS SELECT ZONE V A
CONFIRM
Recommended Freezer Temperature
FREEZER
RECOMMENDED
;"1 °F
LI
BACK UNITS SELECT ZONE V
CONFIRM
Save/Confirm Temperature Settings
• When you have finished adjusting both the refrigerator and
freezer set points, press MEASURED FILL to confirm and to
save the settings.
NOTE: To exit Temperature mode without saving changes, press
the ICE/WATER button under Back at any time, or allow about
60 seconds of inactivity. The temperature mode will turn off
automatically and return to the normal screen.
When adjusting temperature set points,
use the following chart as a guide:
REFRIGERATOR too cold REFRIGERATOR Setting
1° higher
FREEZER too cold FREEZER Setting
1° higher
............................................................... r r r r r r
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is
turned off.
• To turn cooling off, press and hold the LOCK and
MEASURED FILL buttons at the same time for 3 seconds.
The Cooling Off icon will blink seven times and then remain lit
as shown.
IM PC RTANT:
• To avoid unintentionally locking the dispenser or changing
other settings, press both buttons at exactly the same
time.
• When cooling is off, the dispenser paddles and all
controls except Lock and Measured Fill are disabled.
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (0°C to 7°C).
Freezer set point range: -5°F to 5°F (-21 °C to -15°C).
1. When Temperature mode is activated, press TEMPERATURE
to select the Refrigerator zone. The display will show the
temperature set point of the selected compartment, as
shown.
2. Press LOCK to raise the set point, or press OPTIONS to lower
the set point.
3. When you have finished viewing (and adjusting if desired) the
refrigerator set point, press TEMP, under Select Zone, to
change the display to show the freezer set point. When the
zone has been changed, "FREEZER" appears on the display
screen.
4. Press the LOCK button to raise the set point, or press the
OPTIONS button to lower the set point.
A. Press LOCK and MEASUREDFILL at the same time.
• Press and hold LOCK and MEASURED FILL for 3 seconds
again to turn cooling back on.
19