Table of Contents
Advertisement
SYMPTOM
CAUSE (AND REMEDY)
No power.
,
Check that the AC power cord is connected.
• The unit is not turned on.
The remote does not
• Remove any obstacles
between the remote and the unit.
function.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
DVD
• Replace the batteries
in the remote with new ones.
No sound or 0nlya
• Make sure that you select DVD mode.
very low-level sound
, The system is in pause mode. press the • PLAY button to return to normal
is heard.
PLAY mode.
Fast-forward or fast-reverse
is performed. Press the • PLAY button to retur n
to normal play mode.
•
Make sure the AUDIO t VIDE© output and AV IN input connections are Correct.
The DTS DVD disc cannot be decoded to have speaker output.
• The unit is too hot. Shut off the unit for 30 minutes to cool it down.
No picture.
• The region number of the disc does not match the region number of this
unit. ___
The
picture
is not
•
Ctean the disc.
clear.
• The disc is scratched.
Severe hum or noise
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened
is heard,
with alcohol.
• Clean the disc.
The
disc
does
not
• Thereis
no discinside
('!No Disc" appearson
the screen).
play.
!nsert the disc correctly with the playback side facing towards.
Clean the disc.
A non-valid
disc has been inserted. The unit and disc regi0n number are
incompatible.
' Condensation
may have formed inside the unit due to a sudden change in
temperature, wait about an hour for it to clear and try again.
TV
Bad Picture
(snow,
• Check the location of the antenna and adjust it if necessary.
multipe
images,
• Make sure the antenna cable is firmly connected.
distortion,
blurry)
• Make sure all input cables are firmly connected.
Black
and
white
. ChecktheVIDEOMENUwithintheTVSETUPMENU.
pi6ture..Check
to make sure the program
you are watching
is broadcast in Color
and not black & white.
No picture or sound.
. Make sure the unit is plugged in and turned on.
. Make sure that TV mode is selected.
. Try a new channel to check for possible station trouble.
• Make sure the antenna is connected
properly.
• Increase the volume.
• Make sure the antenna or audio video source device is working
properly.
• Make sure all cables are firmly connected.
• Check for local interference.
Colored
patches
of.
Make Sure there are no unshielde d electrica!
devices
nearby
that are
picture .
causing
interference.
• Turn the unit off for 30 minutes,
then try it again.
No sound
is output
• Check the connection
between this unit and the HDMI out jack of other
from the HDMI out
equipment.
• See if the TV supports this 480p/576p/720p/1080i
DVD system.
• Check your TV system setup correctly.
• Make
sure your TV supports
HDCP
(High Bandwidth
Digital
Content
Protection).
E - 29
Advertisement
Table of Contents
