Connect Pc And Call - Plantronics Voyager Legend UC User Manual

Connect PC and Call

1 Power headset on.
2 Insert Bluetooth USB adapter directly into your PC USB port. The LED will flash and then turn
solid blue to indicate the headset is connected to the USB adapter. The LED remains solid blue
when not on an active call.
NOTE
Insert your Bluetooth USB Adapter directly to your laptop or PC instead of connecting to a USB
port on the docking station or hub.
3 Load Plantronics Spokes software by visiting
"Download" button.
NOTE
Spokes software allows you to customize your headset's behavior through advanced settings
and options.
4
Check your Audio Settings.
Confirm the speaker and microphone settings for your PC softphone are set to Plantronics
BT300.
PC Audio Setup for Windows 7 and Windows 8
Go to Control Panel -> Sound-> Playback tab, and set the Plantronics BT300 device as the
Default Communications Device. Next go to the Recording tab and set Plantronics BT300 as the
Default Recording Device. If you plan to listen to streaming audio set the Plantronics BT300
device as the Default Audio Device as well. In the Playback tab, this is indicated by the green
checkmark.
PC Audio Setup for Windows XP
Go to Control Panel -> Sounds and Audio Devices, and in the Audio tab set the Plantronics
BT300 as the default device for the Sound playback and Sound recording sections.
5 Place a call from your computer softphone. During an active call, the Bluetooth USB adapter will
flash blue.
Bluetooth USB Adapter LED indicators
Headset powered off
Paired/connected
Active call or audio
plantronics.com/software and click on the
None
Solid blue
Flashing blue
16