Serial Ata (Sata) Interface; Hot-Plug Compatibility; Serial Ata Device Plug Connector Pin Definitions - Seagate Enterprise Capacity 3.5 HDD/Constellation ES Product Manual

6.0 S ATA (SATA)
ERIAL
These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output
(PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6.
For detailed information about the Serial ATA interface, refer to the "Serial ATA: High Speed Serialized AT Attachment" specification.
6.1 H -P
OT LUG COMPATIBILITY
Constellation ES Serial ATA drives incorporate connectors which enable you to hot plug these drives in accordance with the Serial ATA
Revision 2.6 specification. This specification can be downloaded from www.serialata.org.
Caution:
The drive motor must come to a complete stop (Ready to spindle stop time indicated in Section 2.7)
prior to changing the plane of operation. This time is required to insure data integrity.
6.2 S ATA
ERIAL DEVICE PLUG CONNECTOR PIN DEFINITIONS
Table 8 summarizes the signals on the Serial ATA interface and power connectors.
Table 8 Serial ATA connector pin definitions
Segment Pin Function
Signal S1 Ground
S2 A+
S3 A-
S4 Ground
S5 B-
S6 B+
S7 Ground
Key and spacing separate signal and power segments
Power P1 V
33
P2 V
33
P3 V
33
P4 Ground
P5 Ground
P6 Ground
P7 V
5
P8 V
5
P9 V
5
P10 Ground
P11 Ground or LED signal
P12 Ground
P13 V
12
P14 V
12
P15 V
12
Notes:
1. All pins are in a single row, with a 1.27mm (0.050") pitch.
2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences
are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate back-
plane configuration.
4.
All used voltage pins (V
x
C ES S
ONSTELLATION ERIAL
INTERFACE
Definition
2nd mate
Differential signal pair A from Phy
2nd mate
Differential signal pair B from Phy
2nd mate
3.3V power
3.3V power
3.3V power, pre-charge, 2nd mate
1st mate
2nd mate
2nd mate
5V power, pre-charge, 2nd mate
5V power
5V power
2nd mate
If grounded, drive does not use deferred spin
1st mate.
12V power, pre-charge, 2nd mate
12V power
12V power
) must be terminated.
ATA P M , R
RODUCT ANUAL
. F
EV
30