Table of Contents
Advertisement
FCC STATEMENT
This
device
complies
with
Part
15 of the
FCC
Rules.
Operation
is subject
to the
following
two conditions:
(1)
This device
may not cause harmful
interference,
and
(2)
This device
must accept
any interference
received,
including
interference
that may
cause undesired
operation.
Note:
This equipment
has been tested
and found
to comply with the limits for Class B digital
devices,
pursuant
to Part
15 of the FCC rules.
These
limits
are designed
to provide
reasonable
protection
against
harmful
interference
in a residential
installation.This
equipment
generates
uses and can radiate
radio frequency
energy
and, if not installed
and used in accordance
with the instructions,
may cause harmful
interference
to radio
communications.
However,
there
is no guarantee
that interference
will not occur
in a
particular
installation.
If this equipment
does
cause
harmful
interference
to radio
or
television
reception,
which
can be determined
by turning
the equipment
off and on, the
user
is encouraged
to try to correct
the interference
by one or more
of the following
measures:
•
Reorient
or relocate
the receiving
antenna.
•
Increase
the separation
between
the equipment
and receiver.
•
Connect
the equipment
into an outlet
on a circuit
different
from that to which
the
receiver
is connected.
•
Consult
the dealer
or an experienced
radiolTV
technician
for help.
Use of shielded
cable is required
to comply
with Class B limits in Subpart
B of Part 15 of
the FCC rules.
Do not make
any changes
or modifications
to the equipment
unless otherwise
specified
in the manual.
If such changes
or modifications
should
be made,
you could be required
to stop operation
of the equipment.
Notice
If static electricity
or electromagnetism
causes
data transfer
to discontinue
midway
(fail),
restart
the application
or disconnect
and connect
the communication
cable (USB,
etc.)
again.
EN-1
Advertisement
Table of Contents
