Advertisement
FM and
AM(Mw/Lw)
Antennas
1
2_
3_
IfAMrecep tieniS
poor, connect an
outdoor AM
antenna(not
suppIied).
AM Loop Antenna
(suppIied)
If FM reception is poor,
connect outdoor FM antenna
FM Antenna (supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM Ioop antenna.
Cooling fan (See "About Cooling Fan" below)
1. Connect the FM antenna supplied to the FM 75£_
COAXIAL terminal as temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If receptionis poor,connectan outdoorantenna.
Beforeattachinga 75_3coaxial cable(with a standard
type connector),disconnectthe suppliedFM antenna.
1. Connect the AM loop antenna supplied
to the AM and _ terminals,
2, If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected),
fiiio(About
the cooling fan)
lingfan is mounted on the rear panel of the center unit to
nt abnormal temperatureinside the center unit, thus assuring
atoperation. The cooling fan automatically starts rotating to
ly external cool air to the inside of the center unit when the
_ internal temperature exceeds the specified limit.
For safety, observethe following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilationcould overheat and damage the canterunit.
• DO NOT blockthe cooling fan and the ventilation openingsor
holes. (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
13
:onnections
For connection to external
equipment with digital output.
Example: CD recorders, MD (Mini Disc) D/A
converters or other components equipped
with digital output jacks
DIGITAL
OUT
E
G
Audio Cable (Red/White)
If the external
analog
component
has only one
output
jack, you may
connect
either
L or R.
R
L
Connect to external equipment with
analog output.
Example: Video, TV, LDP, etc.
Always connect the video and
audio connection cables to the
equivalent colored jack.
Press the AUX button and select AUX1 IN, AUX2 IN.
and select AUX1 IN, AUX2 IN.
14
Advertisement
