Advertisement
• Is the disc installed with the label side facing up?
The disc tray does not
• Is the power cord plugged securely into the power outlet?
open.
• Turn off the power to the unit by pressing the Power ((_/I)
button
and turn it back on.
• Check the region number of the DVD.
Disc does not play.
• DVD discs purchased abroad may not be playable.
• This player cannot play CD-ROMs, DVD-ROMs, etc.
• Check the rating level of the DVD.
Playbackdoes not start
immediatelywhen the
• Check whether the disc has any scratch marks or is deformed.
Play/Pause button is pressed.
No sound is produced.
Sound can be heard only
from a few speakers and
not all six.
Picture doesnotappear; s ound
isnotproduced; thedisctray
opens 2.5seconds l ater,
Sound quality is
irregular.
Dolby Digital 5.1 Channel
Surround Sound is not
being reproduced.
• No sound is heard during high-speed playback, slow playback,
and step motion playback modes.
• Are the speakers properly connected? Is the speaker Setup
correctly customized?
• Is the disc severely damaged?
The disc may be dirty. Wipe off fingerprints or dirt.
• When listening to a CD or radio, sound is output to the front
speakers only (L/R). Select the "PRO LOGIC" option by pressing
the Pro Logic button on the remote control unit to use all six
speakers.
• Check whether your DVD disc is 5.1 CH compatible.
• Was the player moved suddenly from a cold place to a warm one?
When condensation forms inside the player, remove the disc
and let the player stand for 1 or 2 hours with the power on.
(You can use the player after the condensation disappears.)
• Are the speaker cables loose?
• Is there any dirt or debris at the end of the speaker connector?
• Does the disc being played show the "Dolby Digital 5.1CH" mark ?
5.1-channel sound is reproduced only if the disc is recorded with
5.1 channel sound.
• Is the DVD player connected to the proper speakers?
• The disc revolves but no
picture appears.
• Picture shows interference
and quality is poor.
Remote control unit does
not operate.
Audio or subtitle language
does not operate.
The Menu button is
pressed but the Menu
screen does not appear.
The screen ratio cannot
be changed.
The desired radio station
cannot be tuned in.
The system is
malfunctioning (the
system does not work or
no sound).
• Is the TV power turned on?
• Are the video cables properly connected?
• Is it the player in PAUSE mode?
• Is there any dirt on the disc, or is the disc damaged?
• It may not be possible to play some DVD discs due to poor
manufacture.
• When a dark scene changes to a bright scene during playback, the
screen may flicker vertically. Some disturbance is normal.
• Is the remote control being used within the appropriate distance
and angle of operation for the unit?
• Are there any obstacles between the remote control unit and the
remote control sensor?
• Are the batteries dead? Is it time to replace the batteries with new
ones?
• The audio or subtitle language features does not operate with
DVDs that do not include multiple audio or subtitle languages.
• Is the remote control being used within the appropriate distance
and angle of operation for the unit?
• Are the batteries dead?
• Does the disc have a Menu?
• You can play 16:9 wide DVDs in 16:9 WIDE mode or 4:3 LETTER
BOX mode or 4:3 PAN-SCAN mode; but 4:3 encoded DVDs only
show in 4:3 ratio. Refer to the DVD disc jacket and then select the
appropriate function.
• Is the antenna installed properly?
• When the antenna's input signal is weak, install an external FM
antenna in an area with good reception quality.
• While the player is in the stop mode, hold the Stop ( • ) button
down on the main unit for over 5 seconds."lNITIAL" appears on the
display and all settings will return to the Factory Preset condition.
The RESET function erases all settings; do not use this
function
unless necessary.
43
44
Advertisement
