Table of Contents
Advertisement
TV 50PA30RQ
is packaged with the base of TV stand separated from the cabinet. To setup the base of TV table stand, please carry
out the installation according to the instructions
below.
Step One
Place the TV faced down on a soft cloth or cushion to prevent the panel from being damaged.
Note:
1. The panel can be scratched
easily, so please choose an absolutely flat surface to place the TV, and use soft cloth or cushion to
protect the TV panel. Do not put TV on table directly.
2. Always unplug the AC cord first when installing or removing the stand.
TV Back cabinet
f
Step Two
Take the base of stand. You should take notice of direction about base installation,
please refer to the picture given right side:
$
Step Three
Tv Front cabinet
Please align seven holes of the base and seven screwholes
of the neck (or align the location labels on the back of base and neck),
then insert the base to the neck.
S
_
Step Four
Then insert seven M4 X 14 screws (all same in size) and tighten them.
i
I
Please refer to the picture
given below:
o!o
ooo
The bottom view of the TV ( Front cabinet faces down)
Pedestal Screws
Quantity
Part #
M4 x 14mm
7pcs
RS01TB414H
Note;
!. Be sure to follow the instructions.
Incorrect installation of the stand may result in the TV falling over.
2. Make sure to distinguish between
the front and back of the Stand base.
3. Make sure that at least two persons lift and move the TV.
z_ Do not insert your fingers into the stand base slot of the TV when installing the stand base.
10
Advertisement
Table of Contents
