Using Direct Entry; Using The Remote To Control Adevice; Modes Of Operation; Front Panel - ProScan PS50710 User Manual

USING THE REMOTE
USING DIRECT ENTRY
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the
code list on the last page of this section, Using the Remote.
3. Press and holcl the button on the remote you want to program,
4. Enter the code from the code list.
5. Release button, and then press ON.OFF to see if the component
responds to the remote commands. If it doesn't, try pressing the
component button and then ON.OFF again.
6. If you get no response, repeat these steps using the next code
listed for your brand, until the component responds to the remote
commands.
USING THE
REMOTE
TO CONTROL A
DEVICE
Once the remote has been programmed successfully, you are ready to
use it to control your devices.
To operate the device:
I. Press the device button (TV, VCRI, VCR2, AUX, or SAT*CABLE) to
set the remote to control the device.
2. Press ON ,OFF to turn the device ON or OFF.
3. Use the remote buttons that apply to that device.
MODES
OF OPERATION
Because this universal remote can control several different
components (DVD player, VCR, Cable Box, etc.) it uses operational
modes triggered by the component buttons. For example if you want
the remote to control the TV, you would press the TV button to put the
remote into TV mode before you could control the TV.
FRONT PANEL
If you cannot locate your remote you can use the front panel of your
TV to operate many of the TV's features.
M[NU Brings up the Main menu. When in the menu system, it selects
highlighted items. Also returns you to the previous menu.
CH v Scans down through the current channel list. In the menu
system, it points down to items and adjusts menu controls.
CH ^ Scans up through the channel list. In the menu system, it points
up to items and adjusts menu controls.
VOL - Decreases the volume. When in the menu system, VOL - is
used to point left to items and adjust menu controls.
VOlt. + Increases the volume. When in the menu system, VOL + is
used to point right to items and adjust menu controls.
POWER Turns the TV on and off.
The Front Panel Block feature disables all
front panel buttons. For more
information, see "Parental Controls," in
the Features and Menus section.
25