Table of Contents
Advertisement
Tracking
Your VCR has automatic
tracking which removes
the streaks or
snow from the picture. Automatic
tracking
is activated when you
insert a tape or turn on the VCR. Occasionally
you may need to
adjust the tracking manually,
especially
if the tape was recorded
on a different
VCR. Just use the TRACKING buttons to remove
the streaks or snow.You
can also use tracking when you pause a
tape to reduce jittering
of the picture.
When you manually
adjust the picture, automatic
tracking
is
turned
off.To turn automatic
tracking
back on, press both
TRACKING buttons
on the front of the VCR at the same time, or
eject the tape and re-insert
it.
Tracking has no effect during recording
- only playback.
Time
Counter
The time counter shows the actual time it takes to record a
program
or play back a segment
of a recorded
tape. It helps
locate the beginning
or end of programs
you taped. The time
counter
resets to 0:00:00 whenever
the tape is ejected from
the VCR.
For example,
if you record a 30-minute
program
at the
beginning
of the tape and you want to go to the end of that
program
to begin another
recording,
you would:
1.
Press INFO twice
to display the time counter.
2.
Press CLEAR to reset the time counter to 0:00:00.
3.
Press FORWARD to forward
the tape until the time counter
reads 0:30:00.
4.
5.
Press STOF_This is the approximate
end of the program.
(You may want to press PLAY to verify.) Now, you can begin
recording
at this spot.
Press INFO twice to remove the time counter from the
screen and return to the normal display mode.
0:30:00
Hours
]
Minutes
Seconds
39
Advertisement
Table of Contents
