Table of Contents
Advertisement
Auto TV/VCR
This feature controls
whether
the TV/VCR switch changes
automatically
to the VCR mode, Press 3 to switch between ON
and OFE
Select ON if you want the VCR to switch to the VCR mode
when the VCR is turned on or a cassette is inserted.
This
only applies if you connect the ANT IN and RF OUT iacks of
your VCR and TV and watch your VCR on channel 3 or 4 of
your TV,
Select OFF if you want the VCR to remain
in the TV mode.
This is useful if you watch your VCR on theTV's video input
and you don't want your antenna/cable
signal interrupted
by
the VCR. Refer to the Connections
section, toward the back
ofthe
manual.
EnergySaver
By default, this VCR automatically
turns off after two hours of
inactivity.
Press 4 to change the time delay, or to disable the
feature,
OFF: The VCR will remain turned
on until you shut it off.
1:00, 2:00, or 3:00: The VCR turns off after one, two, or three
hours of inactivity.
Thirty seconds before shutting
off, the VCR will warn you with a
screen reading, "The VCR will turn off in 30 seconds. Press any
key to cancel."
If you use the VCR's tuner instead of yourTV
to tune channels,
you may want to turn this feature off.
16
Advertisement
Table of Contents
