Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; How To Program The Remote - RCA 31GT750YX3CA2 User Manual

Using the Remote Control
You'll use these buttons when you program the
remote to operate another component.
The remote may not operate all models of
all brands,
Programming the Remote to Operate
Other Components
The universal remote control can be proglvJmmed to operaw most
b_vmds of remote controllable VCRs, sawllite receivers and cable boxes.
The remote is already programmed m operate most R(_, GE and
PROS(_N TVs, VCRs, DVD plwers, laserdisc players and sawlliw
receivers•
Find Out If You Need to Program the Remote
To determine whether the uni_ ersal remote needs to be programmed,
turn a component ON, such as a VCR, point the remote at the VCR, and
press the VCR1 button. Then press ON.OFF or channel up or channel
down to see ff the _ CR responds to the remote commands. If not, the
remote needs to he programmed•
How to Program the Remote
There are two ways to program the remote control: automatic code
search and direct entry. Instructions {br both ways {bllow.
Tip
To stop the automatic code search without
programming any components, press and hold CLEAR
until the light on the remote turns off.
Using Automatic Code Search
1. Turn on the component you want the remote to operate (VCR, DVD
Player, etc.)
2•
3•
4•
5•
Press and hold the component button on the remote control that
corresponds m the component you want the remote to operate
(VCR1, DVD, etc.). While you hold down the component button,
press and hold ON.OFF (when the red light on the remow turns
on, release both buttons).
Press P_Y (the red light on the remote, located below the
ON.OFF button, starts flashing).
The remote is searching the first set of component codes (there are
20 sets of codes). If the component you want to operate doesn't turn
off automatically after 5 seconds, press PLAY again (the red light
starts flashing again as the remote searches through the next set of
codes)•
Continue pressing PLAY until the component turns off
Note: I/'the component cluestz 't turn q[]'q/?er you >e pressed the
PlAY butto*_ 20 time._; the componetzt can 'l be programmecl.
Press P.EVERSE, wmt 2 seconds. Repeat this step until the
component turns back on.
To finish, press and hold the STOI button until the red light on the
l-_'lllOt_' turns o[_.
24